Stub Axle End – 3,500 lb – 6 on 5.5 Bolt Pattern
Part Number: STUB-84-655-H
Stub axle end kit for 3,500 lb trailer axles using a 6 on 5.5" bolt pattern. Designed to replace a damaged spindle section without replacing the entire axle beam. Includes hub, bearings, seal, dust cap, spindle, and related hardware. Services one side of the axle.
Kit Includes
- 1 × 3,500 lb Idler Hub – 6 on 5.5" bolt pattern
- 5 × Lug Nuts
- 1 × L44649 Outer Bearing
- 1 × L68149 Inner Bearing
- 1 × 10-19 Grease Seal
- 1 × 1.98" Dust Cap
- 1 × SP-20084NWC Spindle (#84, 2" round base)
- 1 × 1" Axle Nut
- 1 × 1" Spindle Washer
A stub axle end is welded to an existing axle tube to restore a worn or damaged spindle. The #84 spindle configuration commonly uses L68149 inner and L44649 outer bearings on 3,500 lb axles.
The 6 on 5.5" bolt pattern is measured across the center of two opposing studs. Proper welding alignment is critical to prevent premature bearing wear and wheel tracking issues. Confirm spindle type, bolt pattern, and bearing numbers before ordering.
Use this diagram to confirm your bolt pattern before ordering.
Specifications
| Specification | Detail |
|---|---|
| Axle Rating | 3,500 lb |
| Bolt Pattern | 6 on 5.5" |
| Spindle Type | #84 |
| Spindle Base Diameter | 2.00" |
| Outer Bearing | L44649 (1-1/16" ID) |
| Inner Bearing | L68149 (1-3/8" ID) |
| Seal | 10-19 |
Verify specifications before installation.